Visitor No.5595465 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Blow Molding (Machine) ==> Trouble shooting Blow molding probelm
Next Topic >>
1
How is the distance between the stretch rod and the bottom of mold?

Fine
2
Poor
4/23/2015 1:09:20 PM By mohsin
Dear if you have problem for the plastic going inside neck than first you increase parison cut delay small and than decrease parison cut time small than increase pre blow air of parison after this all you short out this problem easily if possible than also decrease speed of hot cutter.
After all if you have problem than please adjust some timer like blow delay increase,blow pin slw dwn delay increase but not more than blow delay it will be less than blow delay.

Fine
Poor
2
12/27/2013 6:55:41 AM By suraj pratap singh sisodiya
Hi
I have been constantly having the problem of plastic going inside neck bores and blocking it.
The issue is also closely related with my hot cutter which turns dark and avoids cutting and thus sticks the parison. I have to regularly assign people to file the cutter in order to remove deposits from the cutter. Any other remedies?
Regards
Balal

Fine
2
Poor
9/3/2013 7:13:42 PM By balal
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2017 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.