Visitor No.6005857 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Injection Molding (Machine) ==> INJECTION MOLDING TROUBLE SHOOTING -- SHORT SHOTS
<< Previous Topic Next Topic >>
1
Urgent Please Assist me to answer the confuse question .

Name four Factors that will Determine the layout of the runner.


State three reson for cooling the mould.

Fine
5
Poor
4/24/2006 4:24:42 AM By Tommy lim
MR.IQBAL,
WE CAN'T PRODUCE HOTFILL BOTTLES BY USING NORMAL BLOW MOULDING M/CS.OR ON SINGLE STAGE M/CS.FOR HOTFILL BOTTLES PREFORM NECK SHOULD BE CRYSTALLINE.
OIL AT 140 DEG.C.TEMP SHOULD BE CIRCULATED IN BLOW SHELL INSTEAD OF CHILLED WATER.SPECIAL DESIGN OF BLOW MOULD IS ALSO REQUIRED FOR HOTFILL BOTTLES PRODUCTION.A SEPARATE OIL HEATING & CIRCULATING SYSTEM IS ALSO USED FOR HOTFILL BLOW M/C.

Fine
1
Poor
1
1/16/2006 7:39:40 PM By ANWAR SHAHID
I Want make Hot fill bottle for juce So can you tell me how is make bottle and Witch machine produce this product or You tell me hot fill process. I waiting your responce. please help me.
Thanks

iqbal

Fine
2
Poor
12/8/2005 6:31:21 AM By iqbal
Dear Messer’s,
Good Morning

We receive your name and address from Google Search.
We are one of leading Importer & Exporter Company here in my area.
We want to need Injection molding machines.

Our mould of Piece Weight is 700gm and 350gm in material PP.
We use PP and ABS material for these machines.
In future we use these machine Acrylic and AS and Nylon material also.

Please tell me mould opening space and Tai Bars Sizes with all specification and CIF price Karachi Pakistan.

We hopeful you will must show your feasible attitude to proceed further in the matter.

Your favorable response will highly be appreciated.
We hope to establish good collaboration with you.
We hope that we shall receive your kind comments in very soon.

You’re truly
sabhat ali

We hope you will send us better response as soon as possible.
We hope to establish good collaboration with you.
Waiting your valuable response

Thanking you in anticipation.
Yours Sincerely,

sabhat ali


Fine
1
Poor
10/3/2005 10:54:32 PM By sabaahtali
Insufficient material;
Injection pressure too low;
Injection speed too slow;
Cylinder temperature too low;
Mold temperature too low;
Insufficient venting;
Sprues, runners or gates too small.

Fine
3
Poor
1
6/29/2005 9:22:02 PM By Kenplas
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2017 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.