Visitor No.6274745 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Machine Trouble Shooting ==> PET falling off the mold after blowing
<< Previous Topic Next Topic >>
1
From one day to another the PETs keep falling off the mold as soon as the mold is done being blown. The same PETs are being used. The molds are tight and aligned properly. Does anyone know what could be the cause? Or if the molds are worn and may need replacement?

Fine
Poor
1/11/2012 11:08:09 PM By billy
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2018 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.