Visitor No.6450693 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Injection Mold ==> PART DESIGN -- DRAFT
<< Previous Topic Next Topic >>
1
To improve part ejection, draft angle should be provided on the inside and outside of part walls in the direction of draw. A draft of 1° per side is adequate for most part designs.

Fine
4
Poor
1
6/29/2005 9:05:43 PM By Kenplas
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2018 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.