Visitor No.6450747 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Injection Mold ==> PART DESIGN -- RADII
<< Previous Topic Next Topic >>
1
Correctly designed parts should include radii to distribute stress and reduce the relative notch sensitivity of the compound. Radii should be included at all sharp corners, inside and out. The inside corner radii should be 0.25 to 0.5 times the wall thickness. The outside corner radii should be 1.25 to 1.5 times the nominal wall thickness.

Fine
1
Poor
2
6/29/2005 9:05:03 PM By Kenplas
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2018 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.