Visitor No.5929727 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Others ==> Plastic closures and Glass Bottles
<< Previous Topic Next Topic >>
1
Hi Forum , Is there any set tolerances on glass botles and plastic closures in terms of Helix angles , Pressure angles, Pitch ,'T' ,'E'and 'S' measurements

Fine
Poor
11/11/2010 7:16:42 PM By Tendai
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2017 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.