Visitor No.5646896 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Education & Research ==> pet bottles
<< Previous Topic Next Topic >>
1
is there dfaft direction for bottle as i have seen opening of bottle diameter is less while bottom diameter is greater. Is there moulding constraint for bottle design or we can mold vice-versa?

Fine
Poor
5/5/2011 3:18:50 PM By sachin bhutada
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2017 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.