Visitor No.5646851 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Blow Molding (Machine) ==> Bottom Bottom Bursts Easily while Dropping
<< Previous Topic Next Topic >>
1
[url=http://dutasterideavodartonline.org/]dutasterideavodartonline.org.ankor[/url] online-purchaselevitra.net.ankor http://20mg-cheapest-pricelevitra.net/

Fine
Poor
1/5/2017 7:36:13 AM By akagaxuveme
[url=http://dutasterideavodartonline.org/]dutasterideavodartonline.org.ankor[/url] online-purchaselevitra.net.ankor http://20mg-cheapest-pricelevitra.net/

Fine
Poor
1/5/2017 6:03:03 AM By ijapuqzi
http://prednisone-order-20mg.com/ - Order Prednisone Online Viagra Pills http://cialis5mg-20mg.com/

Fine
Poor
8/4/2016 7:09:31 AM By agexexetuyoid
http://prednisone-order-20mg.com/ - Prednisone Withour Prescription Prices Viagra http://cialis5mg-20mg.com/

Fine
Poor
8/4/2016 6:53:43 AM By zdibevaqu
http://prednisone-order-20mg.com/ - Prednisone 20mg Cheap Viagra Pills http://cialis5mg-20mg.com/

Fine
Poor
8/4/2016 3:12:47 AM By ayavobar
http://prednisone-order-20mg.com/ - Prednisone Without A Prescription Viagra Pills http://cialis5mg-20mg.com/

Fine
Poor
8/4/2016 2:54:58 AM By eqeifosoqi
1. Preform bottom is not well stretched (too thick or too thin);
2. Preforms are made of depolymerized PET resin. Make sure PET resin is properly dried, and lower injection temperature is applied.

Fine
Poor
2/15/2006 3:52:41 PM By Kenplas
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:

Message:

(Max. 2KB)



Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2017 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.